Panasonic Omnivision PV-M2738 - Page 8

One Time Setup
When the Combination VCR is turned on
for the first time, it automatically enters the
setup mode. Setup includes the following:
• Choose the language for on-screen
menus and messages.
• Tell the Combination VCR how your
equipment is hooked up (page 5) so the
Combination VCR can correctly place
channels into memory.
• Get the Combination VCR ready for clock
set.
Check list before you begin.
Q Your Combination VCR Is connected to an
Antenna or Cable system (see page 5).
To Set Language, Channels, and Clock
1 Press POWER to turn the Combination VCR on.
2 Press CH AV , or VOL^ for on
screen displays in English,
Spanish or French.
• If you choose the wrong language,
please see the “Reset all Combination
VCR Memory Functions” section on
page 25.
• If you use a cable box, the cable box must be left on for auto
channel set.
SELECT LANGUAGE
PUSH CH A :E r g I 18 ri
PULSE CH T :E«paAol
APP. VOL + iFrarpais
Important: If you use a cable box, turn it on and select
the PBS station In your time zone.
3 Press CH A to start Channel
Auto Set and Clock Auto Set.
These on-screen displays will
appear in sequence.
• CH AUTO SET PROCEEDING
• CH AUTO SET COMPLETED
• AUTO CLOCK SET PROCEEDING
CHANNEL/CLOCK AUTO SET
CONNECT ANTENNA CABLE
AND IF YOU USE A CABLE
BOX, TUNE I T TO YOUR
LOCAL PBS CH THEN. . .
PLEASE PUSH CH UP KEY
}[ _
or
7/28/1998 TUE 12:00PH
DST: ON
SETTING : CH 10
(case 2^
AUTO CLOCK SET
AUTO CLOCK SET
IS INCOMPLETE
COMPLETED
END ; PUSH CH UP KEY
PUSH MENU TO SET CLOCK
4 (case i) If the displayed time is correct, press CH A to
exit.
• This concludes one time Combination VCR setup.
• See important note at the bottom of this page.
If the displayed time and DST. are not correct...
If you happen to live close to two time zones, the Combination VCR may
have recognized the PBS channel (setting channel) in the wrong time
zone. Please do the following to correct the situation.
a. Make a note of the SETTING: CH number shown on-screen and
press CH A to exit.
b. Delete the setting channel from the Combination VCR channel memory.
(See the Add or Delete a Channel section on the next page.)
C. Press MENU to display the MAIN MENU.
d. Press to select “CLOCK,” and then press MENU to display
the SET CLOCK screen.
• If you use a cable box and have multiple PBS stations, tune the
cable box to a different PBS station and try auto clock set again
using the menu.
e. Press at to select “AUTO SET,” and then press ► to set and CH a
to start Auto Clock set.
Using the AT’^^ keys
Whenever a menu or program
screen is displayed, CHANNEL
UP/DOWN and VOLUME UP/DOWN on
the remote control function as AT^^
only. For VOLUME UP/DOWN functions,
use the buttons on the Combination VCR.
8
IMPORTANT NOTE FOR AUTO CLOCK SET
• Auto clock set will be performed when the Combination VCR is
turned off the first time each day. If you use a cable box and you
want auto clock set to be performed, the cable box must be left on
and tuned to the PBS channel at the time the Combination VCR
power is turned off.
• If for any reason the time is changed manually, automatic time
correction will not occur.