Your Palmcorder may be connected to a TV to play
back tapes or to monitor what you are recording.
(TV with AUDIO/VIDEO IN Jacks. )
Back
Audio/Video
Cable
(Supplied)
Go Audio/Video Out_
(TV without AUDIO/VIDEO IN Jacks_
Connect your Palmcorder to a powersource (Battery Pack, AC Adaptor or
Car Battery cord).
POWER
2
VCR CAMERA
Set the POWER switch to VCR to
playback a tape.
Or, set to CAMERA to monitor what your
Palmcorder is recording.
Turn the TV ON and set it to LINE
INPUT.
Check your -IV operating instructions
for further information.
Note:
If your-IV has no VIDEO orAUDIO IN
Jacks, select CH 3 or 4 on your-IV to match
the RF Adaptor CH 3/4 switch and set the
VCRiTV selector on the RF Adaptor to VCR.
Start playback or begin a recording.
_To Audio/Video Out_
RoFAdaptor_ T_ HF Antenna)
ptional) j)
CH 3/4 Switch _llJ 300ohm-75ohm
__ [J transformer
(not supplied)
or F Connector
VCR/TV
UHF Antenna
VHF Connecting
Cable
(not supplied)
TToVHF
erminal
This feature allows you to remove all
Electronic Viewfinder Indications.
Before inserting a tape, press DISPLAY
and STOP together for more than one
second to remove the indications except
time and date*.
To display the Electronic Viewfinder
Indicationsagain, turn the Palmcorder
Power off and then again on.
*To remove the time and date, refer to
page 13.
If you have connected the Palmcorder to
yourTV using an RF Adaptor:
POWER
OFF
VCR ¢AMEI_
Set the POWER switch to OFF on the
Palmcorder.
*Then, set the VCR/TV Selector on
the RF Adaptor to TV.
Now, turn the TV ON and select a
channel.
21
To Next Page
Loading...
