PV-IQ304 PV-IQ404
Turn the EVF Eyepiece counterclockwise 1/8 of a turn (_ While sliding the EYEPIECE REMOVE button O,
and pull free (_. remove the eyepiece _). (Do not twist.)
Remove any lint or dust particles with a soft clean cloth
being careful not to scratch the glass surfaces. Line up
the marks on the Eyepiece with the grooves inside the
EVF shaft and attach. Turn the EVF clockwise 1/8 of a
turn to lock in place.
Then, remove any lint or dust particles with a blower,
available at photography stores. Do not touch lenses
with fingers.
Now, replace the eyepiece.
To Remove To Remove
EYEPIECE RELEASE button
FCCWarning: Any unauthorizedchanges or modificationsto thisequipmentwouldvoidtheuser'sauthorityto
operate.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with Part 15 and part 18 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when operated in a
residential environment.
If this equipment does cause interference to radio or television reception, which can be determined by turning the
equipment off and on, use the equipment in another location and/or utilize an electrical outlet different from that
used by the receiver.
If necessary, consult the dealer or an experienced radio/-rv technician for help. You may find the booklet,
'Something About Interference' available from FCC local regional offices helpful.
27
To Next Page
Loading...
