Panasonic Palmcorder IQ PV-IQ404 - AC Adaptor and Car Battery Cord

C Input "_
onnectorj/
Power Indicator
Lamp
DC(_"_utput'_ _ 2 _-_
LConnectorJ []
1
Connect the DC Output on the AC
Adaptor to the DC Input on the
Palmcorder withthe DC Power Cable
(supplied).
2
Plug in the AC Adaptor.
• The Power indicator will light up.
BAI-I'ERY
REFRESH
POWER CHARGE
o
Note:
AC Adaptor does not function while
charging the Battery.
_CoC Input
nnectorj)
Car Battery
Cord (optional)
Cigarette Lighter_
ocket (12V) j/
2
Cigarette _'_
ighter Plugj)
1
Connect a PV-C16 Car Battery Cord to
the DC Input of the Palmcorder.
2
Start your car engine and then insert the
Car Battery Cord plug into your
cigarette lighter socket.
• There is a fuse located in the lighter plug
end of the cord.
Should fuse replacement be necessary
use the exact current rating (in amps).
Note:
This cord can only be used invehicles
equipped with DC 12V (negative ground)
batteries.
Use only the specified car battery cord.
9