Panasonic Palmcorder PV-D427 - Copying Your Tapes (Dubbing)

Copying
your
Tapes
(dubbing)
Main
Operation
Before
you
begin...
•
Connect
the Palmcorder
to VCR as
shown
below.
•
Turn
ON
both units.
•
Set
the
recording VCR's
input Signal
Selector to
LINE.
•
Set
the
Palmcorder
POWER
switch to
VCR.
Source
(Playing)
Palmcorder
Insert a pre-recorded tape
into the
Palmcorder
and
a
blank
tape with a
recording
tab
into
your
VCR.
Press
PLAY
on
the
Palmcorder and
when you find the starting point,
press
STILL.
Press PLAY and
REC
together on
your VCR
and then
immediately
press STILUPAUSE.
Ainesm. stop rew play
Audio/Video Out
—Audio/Video
Cable
(supplied)
VHF Connecting Cable
(not supplied)
VCR Buttons
Press STILL on the
Palmcorder
and press
STILL/PAUSE
on
the
VCR to
simultaneously
start both
units.
'
Press STOP on
both
units
when
dubbing is
complete.
To Video In
Monitor with your TV
•
Turn the TV
ON
and select Its
VCR
channel
{CH3 or CH4).
•
Set the VCR/TV Selector on the
recording VCR
to
VCR.
Note:
•
Tapes
recorded
on
other
VCRs and used
for playback in the
Palmcorder
must be
recorded
in
SP or SLR
mode.
•
For technical reasons,
dubbing
a tape
may
reduce its
quality.
CAUTION:
—
—
Unauthorized
exchanging and/or
copying
of
copyrighted
recordings may be
copyright
infringement.
35