Panasonic Panafax UF-7000 - Authentication Setting

13
Setting Machine
Continued on the next page...
Authentication Setting
The system administrator can enable/disable the user authentication for each function (copying, faxing,
scanning, and printing).
Press
FUNCTION
SET
.
ENTER ACCESS CODE
Enter the access code (4-digit) set for the machine, and press
SET
.
ENTER ACCESS CODE
****
Press , and then press
SET
.
FAX PARAMETER(1-182)
NO.=
SET
SET
SET
SET
: Selects the scanner function.
: Selects the printer function.
: Selects the fax function.
: Selects the copy function.
Select the function where authentication is required.
126 USER AUTH
1:COPY
Select "VALID" to use authentication or "INVALID" to disable authentication.
126 USER AUTH
2:VALID
SET
: Disable authentication.
SET
: Enable authentication.
When user authentication is enabled for the rst time, you also need to
specify the TIME ZONE, system administrator's name, and password.
Note:
The Sender Selection feature is not enabled if the fax function is set to require
the authentication.
For details, refer to the Operating Instructions for Internet Fax/Email and Network
Scanner Functions.