Panasonic Panafax UF-S2 - Page 78

» Customizing Your Apparatus
3. FAX SETTING
Parameter
SILENT RCV
RING COUNTER
F/T RING COUNTER
Selection Comments
Select whether the apparatus will receive documents without ringing.
Set the number of initial rings before the apparatus answers. This function
will not be valid unless the "SILENT RCV" is set “OFF”.
| (See Notes 2 and 3) mS
Set the number of rings that the apparatus will alert the caller when set to
the Fax/Tel Auto Switching mode.
MANAGING F/T OGM
Select to record, play back or erase F/T OGM.
SILENT DETECTION
Select Silent Detection in Fax / Built-in TAM Mode,
OFF
RESOLUTION HOME
POSITION
FINE
HALFTONE
oe Ee ed
‘| STANDARD | Select required home position for your document.
COMM, JOURNAL
SUBSTITUTE RECEPTION
FRIENDLY RCV
REMOTE RCV
SELECTIVE RCV
OVERSEAS COMM.
ING
OFF
ALWAYS
ON
OFF
Select the printing condition for the COMM. Journal.
e INC : Print only when the transmission has failed.
° OFF : Do not print.
* ALWAYS: Print after each transmission.
Select whether the apparatus receives into memory when recording paper
runs out, (See page 73).
Select whether the apparatus continues to monitor for a fax signal when a
call is answered using the fax handset. (See page 50),
Select whether the apparatus accepts the remote reception command to
-+—————— switch into fax reception mode.
(See page 47).
Select whether the apparatus performs selective reception function.
(See page 71).
Select whether the apparatus uses the overseas setting
communications.
to improve
1) Note: 1. Depending on the PBX conditions when the fax apparatus is called, the number of rings can be differed
7
from the setting.
2. The contents of Fax Parameter may differ depending on the each country’s regulation or specification.
3. Callers are accustomed to calls being answered normally within about 10s, and the majority abandon calls
that are not answered within 45s.