Panasonic Panafax UF-S2

Digital Telephone Answering System <q
Toll Saver
It is possible to check if there is any new ICM (Incoming Message) recorded. When calling from a remote
location, simply listen to the number of rings before the apparatus answers. If there is a new message, the
apparatus answers after the second ring. If there are no messages, the apparatus will answer after the Sth
ring. Therefore, if you hear the third ring you can hang up to save the toll and time.
(You must set TAM SETTING (See page 75, 76) [TOLL SAVER] to ON” in advance.)
When your apparatus has a new message. When your apparatus has no new messages.
1 Call your apparatus from a remote
Call your apparatus from a remote
location.
location.
ring. apparatus answers.
handset to save the toll.
You may listen to the messages following
the Remote Control operation.
2 Your Apparatus will answer after the 2nd | 2 Listen to the number of rings before the
| 3 If you hear the 3rd ring, replace the
\
Call Screening
This function enables you to monitor the incoming call through the speaker. You need to set press OUT button
to turn the lamp ON. (See page 75, 76)
Note: The [RING COUNTER] setting in the FAX SETTING is ignored when the [TOLL SAVER] is set to "ON". (See
page 75, 76)
60