Panasonic Panafax UF-S2

e Troubleshooting
If You Have Any of These Problems
81
Mode
During Installation
During Transmission
Transmission
Copy Quality
During Reception
Print Copy Quality
Symptom
The display is blinking
Document doesn’t
feed
Vertical lines on the
transmitted document
is blank
No recording paper
Recording paper
doesn't eject after
printing
Vertical lines printing
on the received
document
Fuzzy print
Missing dots or
lines/inconsistent
darkness within print
Faint print
Action
Page
This may happen at first installation. After setting the clock, the | 16
blinking will stop.
1. Check that your document is free of staples and paper
clips, and is not greasy or torn.
2. Check that your document is the right type to send through
a fax apparatus by referring to list on "Documents You
Cannot Send”. If your document has the characteristics
tisted, make a copy of your document and send the photo
copy instead.
3, Check that the document is properly loaded.
Check own copy quality. If copy is OK, your apparatus has no
problem, report to receiving party that they have a problem. If-
copy is bad, clean the Document Scanning Area.
Transmitted document | 1. Make sure the document is set face down.
2. Check own copy quality. If copy is OK, your apparatus has
no problem, report to receiving party that they have a
problem. If copy is bad, clean the Document Scanning
Area.
The information code will appear on the display ifthe paper runs
out.
Check to see if the recording paper is jammed inside the
apparatus.
Check own copy quality. If copy is OK, your apparatus has no
problem, report to sending party that they have a problem.
Make sure you are using the correct paper for the best possible
print quality.
Make sure you are using the correct paper for the best possible
print quality.
You may need to choose a different paper for the best possible
print quality.