Panasonic PT-AE2000E

ENGLISH - 21
Basic Operation
Projecting an image
1. Switch on the connected devices.
Press the play button of the required device.
2. Press the INPUT button to select the required input
method if needed. See “Switching the input signal”
on page 23.
The image will be projected on the screen.
1. Press the ASPECT button to select the required
aspect mode. See “Switching the aspect ratio” on
page 23.
2. Adjust the projected image with the lens shift dials.
See “Lens shift and positioning” on page 16.
3. Adjust the angle of the projector.
Screw down the front leg adjusters and adjust the
angle vertically.
See “Front leg adjusters and throwing angle” on
page 15.
4. Adjust the focus and the projected image size.
Press +/- of the FOCUS and ZOOM buttons to
adjust.
Press the LENS button to adjust the focus and zoom
by the remote control. See........................
Selecting the input signal
NOTE:
• AUTO SEARCH is ON as default and the signal from
the connected devices is detected automatically. See
“AUTO SEARCH” on page 40.
Positioning the image
NOTE:
• Do not touch the air exhaust port as this may cause
burns or injury.
• If keystone distortion occurs, see “KEYSTONE” on
page 38.
• If you adjust the focus, you may need to adjust the size
of the image by pressing the ZOOM button again.