Panasonic PT-AE900U

Select the desired device code while referring to the device
code list ( p.24, 25), and then press [ENTER].
✱ If “ERROR” is displayed
The remote control signal that you are trying to learn has
already been registered, so the device code cannot be
selected. To set a device code, clear the remote control signal
that has been learnt. ( p.14)
8
9
■ Selecting and entering device codes
1
2
Press [SETUP] for 3 seconds or more.
Select the device to be set and then press [ENTER].
3
Continue to step 3
B When “TV/TNR” is selected
B When “USER 1-3” is selected
TV
CBL
SAT
DVD
AMP
SCREEN
LIGHTING
SATCBL
HVAC
TV
RCV
VCR
Continue to step 3
Setting remote control signals for home theatre systems
2
-1
Press [ENTER].
2
-2
Select the device to be set.
2
-1
B When “DVD, VCR, AMP” is selected
When “USER 1-3” is selected
Note:
B For device codes that have a power remote control signal, the power remote
control signal for the device will be transmitted when the device code is
selected. Turn the power for the device on as a test.
B Two or more equipment codes cannot be entered for the same device.
B Device codes cannot be entered for “PJ”.
B If the home theatre system device does not support this function, it will not
operate when the buttons are pressed.
Select the device to be set
and then press [ENTER].
Press [SETUP] to finish.
Note:
B If correct operation is not possible
If you find several code numbers when referring to the device code list, try
setting one of the other numbers instead.