Projecting
ENGLISH -
33
Basic Operation
Check the connections of the peripheral devices and connection of the power cord (
Æ
page 30) and switch on the
power (
Æ
page 32) to start the projector. Select the image and adjust the state of the image.
Selecting the input signal
Select an input signal.
Press <INPUT> button on the control panel or the <INPUT>, <COMPUTER>, <HDMI>,
<VIDEO>, <S-VIDEO> on the remote control.
The image of the signal being input in the selected terminal is
z
projected.
Press <INPUT> button to display the [Source] menu. Press
z
▲▼ to select the desired input and press ► to enter.
How to adjust the state of the image
Adjust the projection angle.1 )
Place the projector parallel to the screen, and then install it on a at surface so that the screen becomes
z
rectangle.
If the image is tilted lower than the screen, extend the adjustable feet to make a rectangle screen.
z
For details, see "Adjusting the Projector's Height" (
z
Æ
page 26).
Adjust the focus.2 )
Turn "Focus Ring" to adjust the image.
Note
It is recommended that the images are projected continuously for at least 30 minutes before the focus is adjusted.
z
If keystone distortion occurs, see [V Keystone] in the [Position] menu (
z
Æ
page 41).
Projecting
Focus Ring
To Next Page
Loading...
