Options
46
- ENGLISH
Settings
Lamp Power Mode
J
Selects desired lamp power mode under
z
different situations.
Press ▲▼ to select [Lamp Power Mode].1 )
Press ► to display the setting dialog box.2 )
Press ◄► to select the desired item.3 )
Normal
Normal brightness.
ECO
Lower brightness reduces the lamp
power consumption and extends
the lamp life.
Note
When set to [ECO], you can extend the power savings,
z
reduced operating noise, the service life of the lamp.
When there is no signal for more than 5 minutes, the
z
lamp power will be decreased automatically for power
saving.
Clear Lamp Hours
J
Reset the lamp usage time after replacing the
z
lamp unit.
Press ▲▼ to select [Clear Lamp Hours].1 )
Press ► to display the setting dialog box.2 )
Press 3 )
▲▼
to switch [Yes]/[No].
Press ► to execute.4 )
Dynamic Black
Use this function to emphasizes detail of dark areas
of the image.
Press ▲▼ to select [Dynamic Black].1 )
Press ► to display the setting dialog box.2 )
Press ◄► to switch [On]/[Off].3 )
On
Emphasizes detail of dark areas of
the image.
Off
Displays with normal quality.
Note
[Dynamic Black] will be gray out and can not be operated
z
when [Picture mode] is set to other mode except [Movie].
High Altitude
Set to [On] when the projector is used at elevation
approx. 1 000 m (3 300 ft) and approx. 3 000 m
(10 000 ft).
Press ▲▼ to select [High Altitude].1 )
Press ► to display the adjustment 2 )
dialog box.
Press ◄► to switch [On]/[Off].3 )
On
For the elevation approx. 1 000 m
(3 300 ft) and approx. 3 000 m
(10 000 ft).
Off
For the elevation below approx.
1 000 m (3 300ft).
Note
When [On] is selected, the speed and the noise of the
z
fan will increase.
Dust Filter Reminder
Set the cleaning cycle of the lters and reset the use
time of the lters.
Press ▲▼ to select [Dust Filter 1 )
Reminder].
Press ► to display the setting dialog 2 )
box.
Filters Remind (Hour)
J
Set the timer to display the Dust Filter Reminder
z
message
(
Æ
page 57).
Press ▲▼ to select [Filter Remind].1 )
Press ► to display the adjustment 2 )
dialog box.
Press ◄► to set the time.3 )
The factory default is 0 hour.
z
You can set the time in 50 hours intervals and
z
the longest set time is 1000 hours.
Cleaning up Reminder
J
Reset the air lter used time to zero.
z
Reset the air lter hour counter after cleaning
z
or replacing the dust lter.
Press ▲▼ to select [Cleaning up 1 )
Reminder].
Press ► to display the setting dialog box.2 )
Press ▲▼ to switch [Yes]/[No].3 )
Press ► to execute.4 )
Note
It is recommended to clean the air lters regularly every
z
500 hours of usage.
Information
Displays the input signal source and setting state
information of the projector.
Press ▲▼ to select [Information].1 )
Press ► to display the information 2 )
dialog box.
Displays [Model Name], [Source], [Resolution],
z
[Software Version], [Color Space] and [Aspect
Ratio].
To Next Page
Loading...
