(4) Unscrew the 4 screws and remove the S-P.C.Board.
12.15. Removal of SL-P.C.Board
(1) Remove the upper case according to the section 12.2. "Removal
of Upper Case".
(2) Unscrew the 2 screws and remove the SL-P.C.Board.
12.16. Removal of K-Module
(1) Remove the signal processing block according to the steps 1
through 4 in the section 12.6. "Removal of G-P.C.Board".
(2) Unscrew the 5 screws and remove the K-Module.
12.17. Removal of B/Q-Module
·
The procedure is described as an example of Ballast-1.
36
PT-D10000U / PT-D10000E / PT-DW10000U / PT-DW10000E
To Next Page
Loading...
