Panasonic PT-DW730E - Connecting External Devices

Connections
30 - ENGLISH
Getting Started
Before connecting to the projector
z
Read carefully the instruction manual for the device to be connected.
z
Turning off the power switch of the devices before connecting cables.
z
If any connection cable is not supplied with the device, or if no optional cable is available for the connection of
the device, prepare a necessary system connection cable to suit the device.
z
Video signals containing too much jitter may cause the images on the screen to randomly wobble or wafture. In
this case, a time base corrector (TBC) must be connected.
z
The projector accepts the following signals: VIDEO, S-VIDEO, analog RGB (with TTL sync. Level) and digital
signal.
z
Some computer models are not compatible with the projector.
z
Use a compensator when you connect each of equipment to the projector using long cables. Otherwise the
image may not be output properly.
■<S-VIDEO IN> terminal pin assignments and signal names
Outside view Pin No. Signal names
(1) (2)
(3) (4)
(1)
Ground (luminance signal)
(2)
Ground (color signal)
(3)
Luminance signal
(4)
Color signal
■<RGB 2 IN> terminal pin assignments and signal names
Outside view Pin No. Signal names
(4)
and
(9)
are not used.
(5)
-
(8)
,
(10)
, and
(11)
are GND
terminals.
(10)
(6)
(11) (15)
(1) (5)
(1)
R/PR
(2)
G/Y
(3)
B/PB
(12)
DDC data
(13)
SYNC/HD
(14)
VD
(15)
DDC clock
■<DVI-D IN> terminal pin assignments and signal names
Outside view Pin No. Signal name Pin No. Signal names
(17)(24)
(16) (9)
(1)(8)
(1)
T.M.D.S data 2-
(13)
–
(2)
T.M.D.S data 2+
(14)
+5 V
(3)
T.M.D.S data 2/4
shield
(15)
GND
(4)
–
(16)
Hot plug detection
(5)
–
(17)
T.M.D.S data 0-
(6)
DDC clock
(18)
T.M.D.S data 0+
(7)
DDC data
(19)
T.M.D.S data 0/5
shield
(8)
–
(20)
–
(9)
T.M.D.S data 1-
(21)
–
(10)
T.M.D.S data 1+
(22)
T.M.D.S clock
shield
(11)
T.M.D.S data 1/3
shield
(23)
T.M.D.S clock+
(12)
–
(24)
T.M.D.S clock-
Connections