Panasonic PT-DW750 - Page 116

Chapter 4 Settings — [PROJECTOR SETUP] menu
116 - ENGLISH
f For continued use longer than 24 hours, set [BRIGHTNESS CONTROL SETUP] to [CALIBRATION TIME], or set [LAMP RELAY]
(x page 113). If it is not set, correction will not be performed automatically.
f The [CALIBRATION TIME] setting will be reected at the time when you enter the time.
f The [CALIBRATION MESSAGE] setting will be reected at the time when items are switched using qw.
Displaying [BRIGHTNESS CONTROL STATUS]
Display the brightness control status.
1) Press as to select [BRIGHTNESS CONTROL].
2) Press the <ENTER> button.
f The [BRIGHTNESS CONTROL] screen is displayed.
3) Press as to select [BRIGHTNESS CONTROL STATUS].
4) Press the <ENTER> button.
f The [BRIGHTNESS CONTROL STATUS] screen is displayed.
[BRIGHTNESS CONTROL STATUS] screen display example
When [MODE] of [BRIGHTNESS CONTROL SETUP] is set to [OFF]
The screen shows the status that the brightness control is disabled.
1
RETURN
BRIGHTNESS CONTROL STATUS
MODE
PROJECTOR
OFF
MENU
When [MODE] of [BRIGHTNESS CONTROL SETUP] is set to [AUTO] and [LINK] is set from [GROUP A] to
[GROUP D]
The screen shows the status of the brightness control of synchronized projectors (up to eight units), including the
projector being controlled through the on-screen menu.
2
1
3
4
5
7
8
1:
2:
3:
4:
5:
6:
7:
192. 168. 30. 2
192. 168. 30. 3
192. 168. 30. 4
LINK
UPDATE
PROJECTOR
GROUP A
PROJECTOR2
PROJECTOR3
BRIGHTNESS CONTROL STATUS
MENU SELECT