Panasonic PT-DZ570E

14
NETWORK menu (continued)
AUTHENTICATION ●
：
Set the user authentication method used by the network to be connected.
OPEN
：
Select when making a connection using [AD HOC], or when the access point
authentication method is OpenSystem
_1
.
SHARED
：
Select when making a connection using [AD HOC], or when the access point
authentication method is Shared Key
_1
.
WPA-PSK
_2
：
Select when the access point authentication method is WPA-PSK
_1
.
WPA2-PSK
_2
：
Select when the access point authentication method is WPA2-PSK
_1
.
ENCRYPTION ●
：
Select the encryption method to be used for communication between the
projector and the network.
NONE
：
Select when transmit without encryption. It is selectable only when
[AUTHENTICATION] is [OPEN] or [SHARED].
WEP
_1
：
Select when ENCRYPTION is WEP.
TKIP
_1
：
Select when ENCRYPTION is TKIP.
Selectable when [AUTHENTICATION] is either [WPA-PSK] or [WPA2-PSK].
AES
_1
：
Select when ENCRYPTION is AES.
Selectable when [AUTHENTICATION] is either [WPA-PSK] or [WPA2-PSK].
1: “Glossary” ( _ See page 40 – 41)
2: Available when the mode is set to [INFRASTRUCTURE]. _
Press [NEXT] after conguration is completed. Select [NEXT] if [WEP] is selected as the encryption method, and
select [STORE] if [OPEN] is selected. At this point, select [RETURN] to go back to the previous screen (1/2), or
select [CANCEL] to cancel the conguration change.
Note
IEEE802.1x is not supported. ・
Important video/audio data is protected because AES encryption processing takes place in advance for all ・
network numbers, even if [ENCRYPTION] is set to [NONE].
If [WEP] is selected as the encryption method, then perform the additional conguration below.
WIRELESS LAN
3/3
DEFAULT KEY
1
KEY1
KEY2
KEY3
KEY4
RETURN STORE CANCEL
MENU SELECT
CHANGE
When setting [OPEN] or [SHARED] as authentication and setting [WEP] as the encryption ●
method:
DEFAULT KEY
：
Set 1 – 4 numerals for the default key.
KEY1 – 4
：
Set these to match the WEP key registered in [DEFAULT KEY] and select [OK].
Either the 64-bit or 128-bit WEP key can be set. For the 64-bit key, input ve
alphanumerics (or a 10-digit string for the hexadecimal format) for the 128-bit key,
input 13 alphanumerics (or a 26-digit string for the hexadecimal format).
When using [WPA-PSK] or [WPA2-PSK] : Set key and select [OK]. ●
Input either 8 to 63 alphanumerics or a 64 digit string in the hexadecimal format.
Note
If you are unable to connect to the wireless LAN through the access point even after performing the steps in ・
“Projector settings (See page 19)”, contact the manufacturer of the access point.