Panasonic PT-DZ570E

15
NETWORK menu (continued)
Default settings of [USER1] - [USER3] ■
The following settings as [USER1] - [USER3] in the wireless LAN are set before the projector leaves the factory.
SSID Panasonic Projector
DHCP OFF
IP ADDRESS 19 2.16 8.11.10 0
SUBNET MASK 255.255.255.0
DEFAULT GATEWAY 19 2.16 8.11.1
MODE AD HOC
AUTHENTICATION OPEN
ENCRYPTION NONE
CHANNEL 11
Press ▲▼ to select [STORE], and press <ENTER> button.
3
Save the current network settings.
Note
When conguration is completed, you need to select [STORE] and press the <ENTER> button. At this point,
select [RETURN] to go back to the previous screen (2/3), or select [CANCEL] to cancel the conguration
change.
NETWORK CONTROL
Set when you want to control the projector from a computer connected to the network.
Press ▲▼ to select [NETWORK CONTROL], and press
1
<ENTER> button.
The [NETWORK CONTROL] screen will be displayed.
NETWORK
PROJECTOR NAME NAME1234
WIRED LAN
WIRELESS LAN
USER1
NETWORK CONTROL
NETWORK PASSWORD
OFF
NETWORK PASSWORD CHANGE
LIVE MODE CUT IN OFF
COMPUTER SEARCH
MULTI -LI VE
NETWORK STATUS
ENTER
MENU SELECT
SUB MENU
Press ▲▼ to select items, and press ◄► to change the setting.
2
WEB CONTROL Set this to [ON] when you want to perform control with the Web browser.
PJLink CONTROL Set this to [ON] when you want to perform control with the PJLink protocol.
COMMAND CONTROL
_
Set to [ON] to control using the control command via the serial
terminal.→See page 38
COMMAND PORT Set the port number used for the command control.
STORE Save the current network control settings.
If settings have been made without an administrator password of the Web browser control, add 2-byte “00” _
instead of STX, and a linefeed code (0Dh) instead of ETX. If settings have been made with an administrator
password of the Web browser control, add a 32-byte hash value and “00” instead of STX and a line-feed code
(0Dh) instead of ETX. The hash value is created by MD5 combining “admin1:”, password, “:” and random
numbers. The random numbers are 8-byte values sent from the projector when connecting.