10.7. Removal of R2-P.C.Board
(1) Remove the upper case according to the section 10.2. "Removal
of Upper Case".
(2) Unscrew the 2 screws and remove the Control Buttons Block.
(3) Unscrew the 2 screws and remove the R2-P.C.Board.
10.8. Removal of R3-P.C.Board
(1) Loosen the 1 screw until it idles, then remove the lamp unit cover.
Note:
·
The lamp unit cover is connected to the main unit with
the connector. Be careful when removing it.
(2) Unscrew the 2 screws and remove the R3-P.C.Board.
29
PT-DZ6710U / PT-DZ6710E / PT-DZ6700U / PT-DZ6700E / PT-DW6300US / PT-DW6300ES / PT-D6000US / PT-D6000ES
To Next Page
Loading...
