Maintenance — Maintenance/replacement
f
Fig. 1
Fig. 2
Lamp unit fixing screws
Lamp cover fixing screw
Lamp unit
Handles
Lamp cover
1) Set the <MAIN POWER> switch to <OFF> and disconnect the power plug from the power outlet.
f Wait at least one hour and check if the lamp unit has cooled down.
Remove the lamp cover. (Fig. 1)
f
in the direction of the arrow to remove it.
f
3)
f
f
4) Push in the new lamp unit while paying attention to the insertion position.
f
Use a Phillips screwdriver to firmly tighten the lamp unit fixing screws (x3).
f
6) Attach the lamp cover.
i) in the reverse order to attach the lamp cover.
ii)
f
Note
f When you replace the lamp unit with new one, the projector resets the runtime of the lamp unit automatically.
Attention
f
f
1) Remove the air filter unit.
f Refer to x.
Attach the optional Replacement Filter Unit (Model No.: ET-RFE300) to the projector.
f Refer to x page 130).
Attention
f
To Next Page
Loading...
