Chapter 6 Appendix — Technical information
PJLink security authentication
The password used for PJLink is the same as that of the password set for web control.
When using the projector without security authentication, do not set a password for web control.
f
Control commands via LAN
Connecting
1)
connection to the projector.
f
IP address
→→
→→→
Check the response from the projector.
Data section Blank Mode Blank
Termination
Command
example
Data length
1 byte 1 byte 1 byte 8 bytes 1 byte
f
3)
f
xxxxxx
yyyyy
zzzzzzzz
Command transmission method
Transmit using the following command formats.
r Transmitted data
Header Data section
Termination
Command
example
(Refer to above)
Data length
32 bytes 1 byte 1 byte 1 byte
r Received data
Header Data section
Termination
Command
example
Data length
1 byte 1 byte 1 byte
To Next Page
Loading...
