Chapter 6 Appendix — Technical information
Basic format
to the details of control.
(2 bytes)
2 ID characters (2 bytes)
Semi-colon (1 byte)
Colon (1 byte)
3 command characters (3 bytes)
Parameter (undefined length)
Start (1 byte)
ZZ, 01 to 64
ID designate
End (1 byte)
Parameter (6 bytes)
*1
Symbol “+” or “-” (1 byte) and setting or adjustment value (5
bytes)
Operation (1 byte)
*1
“=” (Set the value specified using parameter)
Sub command (5 bytes)
Same as the basic format
*1 When transmitting a command which does not need a parameter, an operation (E) and parameter are not necessary.
Attention
f
sending or receiving any command after 60 seconds.
f
Note
f
f
f
f
g
g When x page 86)
f
To Next Page
Loading...
