Chapter 3
Basic Operations — Switching on/off the projector
ENGLISH - 47
When the initial setting screen is displayed
When the projector is switched on for the rst time after purchase as well as when [INITIALIZE ALL] in the
[PROJECTOR SETUP] menu is executed, the focus adjustment screen is displayed after projection starts, then
the [INITIAL SETTING] screen is displayed. Set them in accordance with circumstances.
In other occasions, you can change the settings by menu operations.
If you press the <RETURN> button or the <MENU> button while the [INITIAL SETTING] screen is displayed, you
can go back to the previous screen.
Focus adjustment
Adjust the focus to display the menu screen clearly.
You may also need to adjust the zoom and shift.
Refer to “Adjusting the focus, zoom, and shift” (
x
page 52) for details.
1) Press asqw to adjust the focus.
2) Press the <MENU> button to proceed to the initial setting.
Initial setting (display language)
Select the language to show on the screen.
After the initial setting completed, you can change the display language from the [LANGUAGE] menu.
1) Press asqw to select the display language.
2) Press the <ENTER> button to proceed to the initial setting.
Initial setting (projector setting)
Set each item.
1) Press as to select an item.
Item Description Page
[PROJECTION METHOD]
Set [PROJECTION METHOD] depending on the installation mode. For details,
refer to “Installation mode” (x page 31).
After the initial setting is completed, you can change the setting from the
[PROJECTOR SETUP] menu → [PROJECTION METHOD].
31, 93
To Next Page
Loading...
