Chapter 4
Settings — [POSITION] menu
ENGLISH - 79
*1 Only for video signal (NTSC) input
*2 Standard signals are input signals with an aspect ratio of 4:3 or 5:4.
*3 Wide-screen signals are input signals with an aspect ratio of 16:10, 16:9 or 15:9.
Note
f
The image size may be switched abnormally when [AUTO] is selected, please set to [NORMAL] or [WIDE] according to the input signal.
f
Some size modes are not available for certain types of input signals.
f
If an aspect ratio which is different from the aspect ratio for the input signals is selected, the images will appear differently from the originals.
Be careful of this when selecting the aspect ratio.
f
If using the projector in places such as cafes or hotels to display programs for a commercial purpose or for public presentation, note that
adjusting the aspect ratio or using the zoom function to change the screen images may be an infringement of the rights of the original
copyright owner for that program under copyright protection laws. Take care when using a function of the projector such as the aspect ratio
adjustment and the zoom function.
f
If conventional (normal) 4:3 images which are not wide-screen images are displayed on a wide screen, the edges of the images may not
be visible or they may become distorted. Such images should be viewed as with an aspect ratio of 4:3 in the original format intended by the
creator of the images.
[FRAME LOCK]
(Only for still image RGB signals input)
This setting is available for specic computer signals. Set when the movie is distorted.
1) Press as to select [FRAME LOCK].
2) Press qw or the <ENTER> button.
f
The [FRAME LOCK] individual adjustment screen is displayed.
3) Press qw to switch the [FRAME LOCK].
f
The items will switch each time you press the button.
[ON] Enables the frame lock.
[OFF] Disables the frame lock.
[CLAMP POSITION]
You can adjust the optimal point when the black part of the image is blunt or it has turned green.
1) Press as to select [CLAMP POSITION].
2) Press qw to adjust.
Status Rough guide for optimal value Range of adjustment
The black part is blunt.
The point where bluntness of the black part improves the
most is the optimal value.
1 ~ 255
The black part is green.
The point where the green part becomes black, and the
bluntness has improved is the optimal value.
Note
f
[CLAMP POSITION] can be adjusted only when a signal is input to the <RGB 1 IN> terminal or the <RGB 2 IN> terminal.
f
Some signals may not be adjusted.
To Next Page
Loading...
