Panasonic PT-FW530

Chapter 4 Settings — [SECURITY] menu
100 - ENGLISH
2) Press the <ENTER> button.
f
The [CONTROL DEVICE SETUP] screen is displayed.
3) Press as to select [CONTROL PANEL] or [REMOTE CONTROLLER].
[CONTROL PANEL] You can set the limitation on the control from the control panel.
[REMOTE CONTROLLER] You can set the limitation on the control from the remote control.
4) Press qw to switch between [ENABLE] and [DISABLE].
f
You can set the limitation on the control by the control panel or the remote control.
[ENABLE] Enable the button operations.
[DISABLE] Disable the button operations.
f
A conrmation screen will be displayed when you change [ENABLE] to [DISABLE], then proceed to Step 5).
5) Press qw to select [OK], and then press the <ENTER> button.
Note
f
When a button operation is performed on the device set to [DISABLE] , the [PASSWORD] screen is displayed.
To continue operations, enter the security password.
f
The [PASSWORD] screen will disappear when there is no operation for approx. 10 seconds.
f
If the operations of both [CONTROL PANEL] and [REMOTE CONTROLLER] are set to [DISABLE], the projector cannot be turned off (cannot
enter standby).
f
Even when you set button operations on the remote control to be disabled, operations of the <ID ALL> and <ID SET> buttons on the remote
control are enabled.