Chapter 7
Appendix — Technical information
150 - ENGLISH
Mode
Display resolution
(dots)
Scanning frequency
Dot clock
frequency
(MHz)
Format
Plug and play*
1
Horizontal
(kHz)
Vertical
(Hz)
COMPUTER1/
COMPUTER2
HDMI/
DIGITAL
LINK
1152 x 864
1 152 x 864 53.7 60.0 81.6 R/H
― ―
1 152 x 864 67.5 75.0 108.0 R/H
― ―
1 152 x 864 77.1 85.0 119.7 R/H
― ―
1152 x 870 1 152 x 870 68.7 75.1 100.0 R/H
l l
1280 x 720
1 280 x 720 37.1 49.8 60.5 R/H
― ―
1 280 x 720 44.8 59.9 74.5 R/H
― ―
1280 x 768
1 280 x 768 60.3 74.9 102.3 R/H
― ―
1 280 x 768 68.6 84.8 117.5 R/H
― ―
1280 x 800
1 280 x 800
41.3 50.0 68.0 R/H
― ―
1 280 x 800
49.7 59.8 83.5 R/H
l*
5
l*
5
1 280 x 800
62.8 74.9 106.5 R/H
― ―
1 280 x 800
71.6 84.9 122.5 R/H
― ―
1280 x 960 1 280 x 960 60.0 60.0 108.0 R/H
― ―
1280 x 1024
1 280 x 1 024
64.0 60.0 108.0 R/H
― ―
1 280 x 1 024
80.0 75.0 135.0 R/H
― ―
1 280 x 1 024
91.1 85.0 157.5 R/H
― ―
1366 x 768
1 366 x 768 39.6 49.9 69.0 R/H
― ―
1 366 x 768 47.7 59.8 85.5 R/H
― ―
1400 x 1050
1 400 x 1 050
65.2 60.0 122.6 R/H
― ―
1 400 x 1 050
65.3 60.0 121.8 R/H
― ―
1 400 x 1 050
82.3 74.9 156.0 R/H
― ―
1440 x 900 1 440 x 900
55.9 59.9 106.5 R/H
― ―
1600 x 900
1 600 x 900 46.4 49.9 96.5 R/H
― ―
1 600 x 900 55.9 60.0 119.0 R/H
― ―
1600 x 1200
1 600 x 1 200
75.0 60.0 162.0 R/H
l l
1680 x 1050
1 680 x 1 050
54.1 50.0 119.5 R/H
― ―
1 680 x 1 050
65.3 60.0 146.3 R/H
― ―
1920 x 1080
1 920 x 1 080
55.6 49.9 141.5 R/H
― ―
1 920 x 1 080
*4
66.6 59.9 138.5 R/H
― ―
1920 x 1200
1 920 x 1 200
61.8 49.9 158.3 R/H
― ―
1 920 x 1 200
*4
74.0 60.0 154.0 R/H
l*
6
l*
6
*1 Signals with l in the Plug and play columns are signals described in EDID (extended display identication data) of the projector. A signal,
which has no l in the Plug and play columns but has an entry in the Format column, can be input. For signals without l in the Plug and
play columns, resolution may not be selected in the computer even though the projector supports them.
*2 Pixel-Repetition signal (dot clock frequency 27.0 MHz) only
*3 When a 1125 (1035)/60i signal was input, it is displayed as a 1125 (1080)/60i signal. But 1125 (1035)/60i HDMI signal is not supported.
*4 VESA CVT-RB (Reduced Blanking)-compliant
*5 Only for PT-FW530
*6 Only for PT-FZ570
Note
f
The number of display dots for PT-FZ570 is 1 920 x 1 200. The number of display dots for PT-FW530 is 1 280 x 800. The number of display
dots for PT-FX500 is 1 024 x 768. A signal with a different resolution is converted to the number of display dots.
f
The “i” at the end of the resolution indicates an interlaced signal.
f
When interlaced signals are connected, ickering may occur on the projected image.
f
DIGITAL LINK input compatible signal is the same as HDMI input compatible signal.
f
When the communication method of the DIGITAL LINK is set to [LONG REACH], the signals that the projector can receive are up to
1080/60p(148.5MHz).
f
Even the above signals exist, some image signals that are recorded in special method may not be displayed.
To Next Page
Loading...
