Chapter 5 Operations — Web control function
ENGLISH - 111
g When the [SETUP] menu → [STARTUP INPUT SELECT] (x page 73) is set to [LAST USED]
Turn off the power when the input other than Miracast is selected or when the projector is in the lighting mode.
If the projector is in standby mode with Miracast input, switch the input to other than Miracast in the [Basic control] page before turning on
the power.
g When the [SETUP] menu → [STARTUP INPUT SELECT] (x page 73) is set to [Miracast]
Switch the input to other than Miracast using the remote control after projection has been started or set [STARTUP INPUT SELECT] to
other than [Miracast] beforehand.
[Advanced control] page
Click [Projector control] → [Advanced control].
If the projection mode is set to lighting mode, switch to the projector mode in the [Basic control] page and click
[Projector control] → [Advanced control].
1
2
3
4
1 [KEYSTONE]
Corrects horizontal/vertical keystone distortion.
2 [PICTURE]
Switches the input.
3 [DIMMER]
Adjusts the brightness.
4 [LENS]
Adjusts the projection lens (focus/zoom).
[Lighting control] page
Click [Projector control] → [Lighting control].
If the projection mode is projector mode, switch to the lighting mode in the [Basic control] page and click [Projector
control] → [Lighting control].
1
2
3
4
1 [PATTERN]
Switches the lighting pattern.
2 [COLOR SETTING]
Switches the color for lighting.
3 [DIMMER]
Adjusts the brightness.
4 [LENS]
Adjusts the projection lens (focus/zoom).
To Next Page
Loading...
