Panasonic PT-JW130FWE

Chapter 7 Appendix — Technical information
ENGLISH - 207
PJLink security authentication
The password used for PJLink is the same as that of the password set for web control.
When using the projector without security authentication, do not set a password for web control.
f For specications related to PJLink, refer to the website of Japan Business Machine and Information System
Industries Association.
URL http://pjlink.jbmia.or.jp/english/
Using Art-Net function
Since projector supports the Art-Net function, the projector settings can be performed via the Art-Net protocol on
the DMX controller or using application software.
Channel denition
The following table lists the channel denitions used for controlling the projector with the Art-Net function.
Channel Control details Performance Parameter Remark
1 Light volume adjustment
100 % 0
Can be set in 256 steps between
100 % and 0 %.
… …
0 % 255
2 Input/mode selection
No operation 0-7
―
HDMI 8-15
Lighting 16-23
No operation 24-255
6 Lens focus
Focus adjustment (-) fast 0-31
―
Focus adjustment (-) moderate 32-63
Focus adjustment (-) slow 64-95
No operation 96-159
Focus adjustment (+) slow 160-191
Focus adjustment (+) moderate 192-223
Focus adjustment (+) fast 224-255
7 Lens zoom
Zoom adjustment (-) fast 0-31
―
Zoom adjustment (-) moderate 32-63
Zoom adjustment (-) slow 64-95
No operation 96-159
Zoom adjustment (+) slow 160-191
Zoom adjust (+) moderate 192-223
Zoom adjustment (+) fast 224-255
8 Power supply control
Power standby 0-63
―No operation 64-191
Power on 192-255
11 Lock
Operation not available 0-127 When “Operation not available”
is set, operations of all channels
become unacceptable.
Operation available 128-255
Note
f If the projector is operated with the remote control or by the control command while controlling the projector using the Art-Net function, the
setting of the DMX controller and the computer application may be different from the projector status. In this case, set “Lock” of channel 11
to “Operation not available” and then set back to “Operation available” so that the controls of all channels are applied to the projector.
Control commands via LAN
When the projector is connected to a computer via a LAN, the computer can use control commands to operate the
projector and query its status.