Panasonic PT-JW130FWE

Chapter 5 Operations — Content Manager
128 - ENGLISH
Music
Extension Audio codec Audio format
aac AAC
Sample rate: Maximum 48 kHz
Channel: Maximum 2 ch
Bit rate: Maximum 384 kbps
mp3
MPEG-1/2 Audio Layer-3
(MP3)
wma WMA
Note
f Some information for still image/movie/music les can be viewed with a computer where relevant les are accessible.
Operation example
g For Windows computer
1. Right-click a le, and click [Properties].
2. Click the [Details] tab.
g For Mac
1. Click a le while holding down the “Control” key, and click [Get Info].
2. Click [More Info].
f The maximum le size that can be used is 2 GB.
The following table shows the playback time when a 2 GB movie le is used. However, the following playback time is an estimate and may
differ depending on the compression method such as encoding and codec.
Resolution Bit rate Estimate of playback time
720 x 240 Approx. 2 Mbps Approx. 120 minutes
720 x 480 Approx. 5 Mbps Approx. 50 minutes
f Files protected by DRM (Digital Rights Management) cannot be used.
f Some les listed as compatible formats may still not be able to be used.
f Use the SD card with high data transfer speed. If the data transfer speed is slow, movie or music recorded in the SD card may not be played
back properly or it may take time to display a still image. (Speed class: Class 10 recommended)
f For SD cards compatible with the projector, refer to “Cards that can be used with the projector” (x page 49).
Computers for the signage setting
The signage setting is performed by connecting a client computer (including iPad/iPhone/iPod touch or Android
terminal) to the projector.
A web browser is required for the setting. Prepare a computer which satises the following conditions beforehand.
OS (Operating System) Web browser
Windows 7/Windows 8/Windows 8.1
Internet Explorer 10.0/11.0
f Except for Internet Explorer 10 for Windows 8 Modern UI and
Internet Explorer 11 for Windows 8.1 Modern UI.
Google Chrome 33
Mac OS X v10.6/Mac OS X v10.7/Mac OS X v10.8/Mac OS X v10.9 Safari 5.0/6.0/7.0
Android 4.1/4.2/4.3/4.4 Google Chrome
iOS 6/7 Safari 6.0/7.0
Procedure of signage setting
The procedure to perform signage setting with the Content Manager is as follows. For details, refer to the
corresponding reference pages.
Playing by registering a schedule
1) Insert an SD card in the SD card slot. (x page 50)
2) Connect the client computer (including iPad/iPhone/iPod touch or Android terminal) and the projector
via LAN. (x page 101)
3) Access the projector from the web browser, and log in to the Content Manager. (x page 129)
4) On the start screen, click the [Schedule] button.
5) Create a timetable. (x page 133)
6) Register a schedule. (x page 158)