Panasonic PT-JW130FWE

Chapter 1 Preparation — Precautions for use
ENGLISH - 19
f Prevent hot and cool air from the air conditioning system to blow directly to the ventilation ports (intake and
exhaust) of the projector.
90 mm (3-17/32") or longer
*2
300 mm (11-13/16") or longer 300 mm (11-13/16") or longer
200 mm (7-7/8") or longer
Air intake port
Power supply unit
Air exhaust port
Main unit
Power supply unit
Main unit
Air intake port
Air exhaust port
90 mm (3-17/32") or longer
*1
300 mm (11-13/16") or longer 300 mm (11-13/16") or longer
200 mm (7-7/8") or longer
Air intake port
Power supply unit
Air exhaust port
Power supply unit
Air intake port
*1 Distance from the wall or ceiling surface which will cover the whole air intake port
*2 Distance from the wall or oor surface which will cover the whole air intake port
f Do not install the projector in a conned space.
When installing the projector in a conned space, provide air conditioning or ventilation separately. Exhaust heat
may accumulate when the ventilation is not enough, triggering the protection circuit of the projector.
Cautions when transporting
f Before transporting, tighten the rotating xing screw and ball joint xing screws (2 locations) using the supplied
Allen wrench (opposite side size 3.0 mm (1/8")). Transporting while they are loose may cause the ngers to be
caught in between or malfunction.
f When the optional Floor Stand Kit is used, hold the bottom of the oor stand attached to the projector, and
handle so that excessive vibration or shock is not applied when transporting. Failure to do so may damage the
internal components and result in malfunctions.
Ball joint fixing screws
Rotating fixing screw
Floor stand