Chapter 4 Settings — [SETUP] menu
76 - ENGLISH
Note
f The projector will go into the standby mode to reect the setting values when [LOAD ALL USER DATA] is executed.
[INITIALIZE]
Return various setting values to their factory default settings.
1) Press as to select [INITIALIZE].
2) Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3) Enter a security password and press the <ENTER> button.
f The [INITIALIZE] screen is displayed.
4) Press as to select an item to initialize.
[ALL USER DATA]
Returns all setting items including [SIGNAGE], [NETWORK], and [E-mail set up] to the factory default
settings.
The projector enters the standby mode to reect the setting values.
[NETWORK/E-MAIL] Returns [SIGNAGE], [NETWORK], and [E-mail set up] to the factory default settings.
5) Press the <ENTER> button.
6) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
f [PROGRESS] is displayed while initialization is being performed.
Note
f When [ALL USER DATA] of [INITIALIZE] is executed, turn the power supply of the interior wiring off and on, or disconnect and connect the
plug of the power cord to the outlet, and then turn on the projector.
[SERVICE PASSWORD]
This function is used by a service person.
To Next Page
Loading...
