Chapter 5 Operations — Content Manager
ENGLISH - 195
6) Click .
f The le selection screen is displayed.
7) Select the still image file to register (1 file at a time), and click the [Open] button.
f The content name entry screen is displayed.
8) Enter any [Content name], and click the [Enter] button.
f For [Content name], up to 24 characters in single byte can be entered.
f Even when the content name is different from the le name, the le name itself is not changed.
f The content is registered in the [Add content] screen.
Content deletion
f To continue to add content, go back to Step 6), or to delete content from the [Add content] screen, go to
Step 9), and to end adding content, proceed to Step 13).
9) To cancel addition of content, click
on the [Add content] screen.
f The mode changes to deletion mode.
10) Select the content for which you want to cancel addition.
f You can select multiple contents.
11) Click the [Delete] button.
12) When the confirmation screen is displayed, click the [OK] button.
13) When addition of contents to register is complete, click the [Save] button.
f Added contents are registered in the SD card.
Note
f You can also register lighting patterns in the SD card as still image contents from the [Timetable] screen of [Schedule].
f To delete or change the registered lighting patterns, refer to “Deleting or changing registered patterns” (x page 196).
To Next Page
Loading...
