Panasonic PT-JW130FWE

Chapter 6 Maintenance — Light source/temperature indicators
ENGLISH - 201
Temperature indicator <TEMP>
Indicator status Lighting in red
Blinking in red
(2 times)
Blinking in red
(3 times)
Status Internal temperature is high (warning).
Internal temperature is high (standby
status).
The internal cooling fan is not running.
Cause
f Is the air intake/exhaust port blocked?
f Is the room temperature high?
f Is [HIGH ALTITUDE MODE] set correctly?
―
Solution
f Remove any objects that are blocking the air intake/exhaust port.
f Install the projector in a location with the operating environment temperature
between 0 °C (32 °F) and 40 °C (104 °F)
*1
.
f Make sure to set the [HIGH ALTITUDE MODE] to [HIGH1] when using the
projector at altitudes between 1 000 m (3 281') and 2 000 m (6 562') above
sea level, and set the [HIGH ALTITUDE MODE] (x page 71) to [HIGH2]
when using the projector at altitude between 2 000 m (6 562') and 2 700 m
(8 858').
f Do not use the projector at high altitudes of 2 700 m (8 858') or higher
above sea level.
f Turn off the power supply of the
interior wiring or disconnect the
plug of the power cord from the
outlet, and then consult your dealer.
*1 The operating environment temperature should be between 0 °C (32 °F) and 35 °C (95 °F) when using the projector at elevations between 1 000 m
(3 281') and 2 700 m (8 858') above sea level.
Note
f If the temperature indicator <TEMP> is still lighting or blinking after taking above measures, ask your dealer for repair.
f When using the projector at elevations lower than 1 000 m (3 281') above sea level, and the operating environment temperature becomes
35 °C (95 °F) or higher, the light output may be reduced to protect the projector. When using the projector at elevations between 1 000 m
(3 281') and 2 700 m (8 858') above sea level, and the operating environment temperature becomes 30 °C (86 °F) or higher, the light output
may be reduced to protect the projector.