Panasonic PT-JW130FWE

Chapter 7 Appendix — Technical information
210 - ENGLISH
Control command
The following table lists the commands that can be used to control the projector using a computer.
r Projector control command/query command
Command Details
Parameter/response
string
Remark (parameter)
PON Power on ―
To check if the power is on, use the “Power supply status query”
command.
POF Power standby ―
QPW
Power supply status
query
000
001
STANDBY status
Power on condition
IIS Input/mode selection
HD1 HDMI
MV1 MEMORY VIEWER
MC1 Miracast
PA1 Panasonic APPLICATION
SI1 SIGNAGE
LI1 LIGHTING
OLP
Light source power
setting
0 NORMAL
QLP
Light source power
setting query
1 ECO
QST Runtime query 00000 - 99999 In hours
OSH AV mute 0 AV mute function off
QSH AV mute function query 1 AV mute function on
AUU Volume up ― ―
AUD Volume down ― ―