Chapter 2 Getting Started — Before the installation
ENGLISH - 35
Projection distance
The dimension in the following table contains a slight error.
Also, it is corrected to become smaller than the specied image size when [KEYSTONE] is used.
r When the image aspect ratio is 16:10
(Unit: m)
Projected image size Projection distance (L)
Diagonal (SD) Height (SH) Width (SW) Min. (LW) Max. (LT)
0.76 (30") 0.404 0.646 0.95 2.10
1.02 (40") 0.538 0.862 1.28 2.81
1.27 (50") 0.673 1.077 1.61 3.52
1.52 (60") 0.808 1.292 1.94 4.23
1.78 (70") 0.942 1.508 2.27 4.94
2.03 (80") 1.077 1.723 2.60 5.65
2.29 (90") 1.212 1.939 2.93 6.36
2.54 (100") 1.346 2.154 3.26 7.07
3.05 (120") 1.615 2.585 3.92 8.50
3.81 (150") 2.019 3.231 4.91 10.63
5.08 (200") 2.692 4.308 6.55 14.19
Projection distance formula
To use an image size not listed in this manual, check the projected image size SD (m) and use the respective
formula to calculate projection distance (L).
The unit of the formula is all “m”. (Value obtained by the following calculation formula contains a slight error.)
When calculating a projection distance using image size designation (value in inches), multiply the value in inches
by 0.0254 and substitute it into SD in the formula for calculating the projection distance.
r When the image aspect ratio is 16:10
Minimum projection distance
(LW)
L = 1.2976 x SD
-
0.0385
Maximum projection distance
(LT)
L = 2.7999 x SD
-
0.0379
To Next Page
Loading...
