Panasonic PT-JW130FWE

Chapter 4 Settings — [NETWORK] menu
84 - ENGLISH
1) Press as to select [Art-Net].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF] Disables the Art-Net function.
[WIRED LAN] Uses the Art-Net function with wired LAN connection.
[WIRELESS LAN] Uses the Art-Net function with wireless LAN connection.
Note
f Refer to “Setting address for [WIRED LAN]” (x page 84) or “Setting address for [WIRELESS LAN]” (x page 85) for how to set the IP
address.
f If [Art-Net] is set to other than [OFF], the [NETWORK] menu → [WIRED LAN] (x page 77) or [WIRELESS LAN] (x page 78) is
disabled.
f If the string of SSID exceeds 16 characters, the SSID is displayed in two lines.
Setting address for [WIRED LAN]
1) Press as to select [Art-Net].
2) Press qw to select [WIRED LAN].
3) Press the <ENTER> button.
f The [Art-Net (WIRED LAN)] screen is displayed.
4) Press as to select [DEVICE IP ADDRESS].
5) Press qw to switch the item.
f The items will switch each time you press the button.
[2.x.x.x] Sets the IP address to 2.x.x.x automatically.
[10.x.x.x] Sets the IP address to 10.x.x.x automatically.
[MANUAL] Sets the IP address manually.
6) Press as to select each item, and change the settings according to the operation instructions of the
menu.
[NET] Enter the net setting of the control console to be connected to the projector.
[SUB NET] Enter the subnet setting of the control console to be connected to the projector.
[UNIVERSE] Enter the universe setting of the control console to be connected to the projector.
[START ADDRESS] Enter a start address where the projector processes Art-Net.
f When [2.x.x.x] or [10.x.x.x] is selected in Step 5), proceed to Step 8).
7) Press as to select each item, and change the settings according to the operation instructions of the
menu.
[DHCP]
Set to [ON] when obtaining an IP address automatically using a DHCP server. Set to [OFF] when not
using a DHCP server.
[IP ADDRESS] Enter the IP address when not using a DHCP server.
[SUBNET MASK] Enter the subnet mask when not using a DHCP server.
[DEFAULT GATEWAY] Enter the default gateway address when not using a DHCP server.
[DNS1] Enter the primary DNS server address when not using a DHCP server.
[DNS2] Enter the secondary DNS server address when not using a DHCP server.
8) Press as to select [STORE], and press the <ENTER> button.
9) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f When the network address is changed in the [NETWORK] menu → [WIRED LAN] (x page 77), the address is reected in the address for
[MANUAL] of this [WIRED LAN] setting.