Panasonic PT-LB20NTU

projector.
Gamma Data Reception:
Receives the gamma data from the projector and writes it in
the file.
Uniformity Data Transmission:
Reads the color unevenness correction data from the file
and transmits it to the projector.
Uniformity Data Reception:
Receives the color unevenness correction data from the
projector and writes it in the file.
Exit:
Exits this application.
8.6.4.2. Receiving and transmitting of the
data
Click a target button and specify a file name.
8.8.2. Explanation of Buttons
OK:
Executes automatic sub contrast and sub brightness
adjustments, then closes this dialog.
Cancel:
Cancels this menu.
8.8.3. Equipment to be used
PC, RGB Signal Generator, Software for Adjustment
8.8.4. Adjustment Procedure
1. Display the input level adjustment [RGB] menu.
2. Input a window pattern signal to RGB IN connector.
Note:
· Use approx. 15 % window pattern as follows.
Black background (screen width) : White window
8.6.5. Adjustment Menu
8.6.5.1. Explanation of Buttons
Input Level Adjustment RGB:
Displays the RGB input level adjustment menu.
Model Info Setup
Displays the model information setup menu.
Exit:
Exits this application.
width = 2 : 1
Black background (screen height) : White window
height = 3 : 1
· PT-LB20NTU/E/EA, LB20U/E/EA, LB20VU/E/EA
must use the window pattern of XGA (1 024 × 768).
· PT-LB20SU/E/EA must use the window pattern of S-
VGA (800 × 600).
3. Click the OK button.
8.7. Flicker Adjustment
According to the procedure of chapter 5 "Flicker Adjustment Mode", minimize the flicker.
8.8. Input Level Adjustment
8.8.1. Adjustment Menu
28
PT-LB20NTU / PT-LB20NTE / PT-LB20NTEA / PT-LB20U / PT-LB20E / PT-LB20EA / PT-LB20SU / PT-LB20SE / PT-LB20SEA / PT-LB20VU / PT-LB20VE / PT-LB20VEA