2 Ext Option
This projector has EXT OPTION in addition to standard on-screen menus.
·
There are SELF CHECK and SERVICE MODE for service, etc.
2.1. Procedure to enter EXT OPTION
1. Press "MENU" button on the main unit or remote control unit to display "MENU" screen, then select "OPTION" and press
"ENTER" button.
2. Select "OSD" on "OPTION" menu and press "ENTER" button 3 seconds or longer.
MENU → OPTION → OSD
2.2. EXT OPTION Menu and Functions
·
FREEZE MSG
Switching ON/OFF "FREEZE" on-screen display
·
ANGLE RESET
Switching ON/OFF "AUTO KEYSTN (Automatic Keystone)" reference level setting
Note:
−
− −
− Normally, do not select. (Angle reset data will be rewritten.)
·
FAN FULLMODE
Setting the cooling fan motor rotation speed
−
− −
− Switching ON "FAN FULLMODE", the rotation level of the fan becomes high-speed rotation (fixed). Moreover, when "FAN
FULLMODE" is ON, changing "FAN CONTROL" in OPTION becomes impossible (setting FAN FULLMODE is given priority
more than FAN CONTROL).
·
AUTOSETUP
Setting AUTO SETUP mode
−
− −
− STANDARD: To set the normal mode (the dot clock is adjusted strictly))
−
− −
− SPECIAL: To set the special mode (the dot clock is adjusted roughly)
Note:
−
− −
− Do not change the initial setting (STANDARD).
·
SYNC
Setting SYNC processing mode
−
− −
− STANDARD: To set the normal mode
−
− −
− SPECIAL: To set the special mode (noise reduction mode)
Note:
−
− −
− Do not change the setting when it is possible to receive normally.
Change the setting only when the image is not displayed normally because of the sync signal noise of connected
equipment.
·
SELF CHECK
To enter the self-check mode
·
SERVICE MODE
To enter the service mode
6
PT-LB20NTU / PT-LB20NTE / PT-LB20NTEA / PT-LB20U / PT-LB20E / PT-LB20EA / PT-LB20SU / PT-LB20SE / PT-LB20SEA / PT-LB20VU / PT-LB20VE / PT-LB20VEA
To Next Page
Loading...
