Panasonic PT-LB50NTE

51
Network setting of the projector (cont.)
ENCRYPTION : Select the encryption method to be used for communication
between the projector and the network.
NONE : Select when transmit without encryption. It is selectable only when
[AUTHENTICATION] is [OPEN] or [SHARED].
WEP
※
: Select when ENCRYPTION is WEP.
TKIP
※
: Select when ENCRYPTION is TKIP.
Selectable when [AUTHENTICATION] is [WPA-PSK].
AES
※
: Select when ENCRYPTION is AES.
Selectable when [AUTHENTICATION] is [WPA-PSK].
Additionally perform the following setting using the [AUTHENTICATION] setting.
When setting [OPEN] or [SHARED] as authentication and setting [WEP] as the
encryption method:
DEFAULT KEY : Set 1 – 4 numerals for the default key.
KEY 1 – 4 : Set these to match the WEP key registered in [DEFAULT KEY].
Either the 64-bit or 128-bit WEP key can be set. For the 64-bit key,
input five alphanumerics (or a 10-digit string for the hexadecimal
format) for the 128-bit key, input 13 alphanumerics (or a 26-digit
string for the hexadecimal format).
When setting [WPA-PSK] as authentication : Set key and select [OK].
Input either 8 to 63 alphanumerics or a 64 digit string in the
hexadecimal format.
※“Glossary” (See page 62)
Important video/audio data is protected because AES
※
encryption processing takes
place in advance for all network numbers, even if [ENCRYPTION] is set to [NONE].
※“Glossary” (See page 62)
DETAILED SETUP
CANCEL
SELECT
USER1 3/3
DEFAULT KEY
KEY1
KEY2
KEY3
KEY4
* * * * * * * *
* * * * * * * *
* * * * * * * *
* * * * * * * *
1
OK CANCELRETURN