Panasonic PT-LB50NTE

50
Network setting of the projector (cont.)
Select [NEXT] on the IP address setting screen, then wireless setting menu appears.
Make the settings related to the wireless LAN connection between the projector and
the network.
Wireless settings
DETAILED SETUP
NEXT CANCELRETURN
USER1 2/3
SSID
MODE
AUTHENTICATIO
N
ENCRYPTIO
N
NONE
AD HO
C
OPEN
Panasonic Projector
CANCEL
ENTER
SELECT
MODE : Select [AD HOC] or [INFRASTRUCTURE].
AD HOC
※
: Connect projector and computer directly without access
point.
INFRASTRUCTURE
※
: Connect through access point.
SSID
※
: If the mode is [INFRASTRUCTURE], enter the SSID
registered at the access point. If the mode is [AD HOC],
enter the same character string as that of SSID set on the
computer to be connected.
AUTHENTICATION : Set the user authentication method used by the network to
be connected.
OPEN : Select when making a connection using [AD HOC], or when
the access point authentication method is OpenSystem
※
.
SHARED : Select when making a connection using [AD HOC], or when
the access point authentication method is Shared Key
※
.
WPA-PSK
※
: Select when the access point authentication method is WPA-
PSK.
※“Glossary” (See page 62)