Panasonic PT-LZ370U

Maintenance/replacement
100 - ENGLISH
Maintenance
2) Pull out the air lter unit.

z
Hold the grips on the air lter unit and pull out the air lter unit from the projector.
Air filter unit
Grips (arrow engraved)
• After removing the air lter unit, remove any large build ups of dirt or dust in the air lter unit bay and the
air intake port on the projector.
3) Clean the air lter unit.

z
Vacuum dirt and dust from the air lter unit.
4) Attach the air lter unit to the projector.

z
Perform Step 2) in the reverse order.
• Insert the air lter unit into the projector in the direction of the arrow engraved into the air lter frame (
)
until it clicks into place.
5) Attach the air lter cover to the projector and use a Phillips screwdriver to tighten
the air lter cover xing screw (one screw).

z
Perform Step 1) in the reverse order.
Attention
z
Make sure that the air lter is properly attached before using the projector. If it is not properly attached, the
projector will suck in dirt and dust causing a malfunction.
z
Do not use water to wash the air lter unit. Doing so decreases its ability to absorb dust.