About your projector
ENGLISH - 23
Preparation
Control panel
(1)
(2)
(3)
(4)
(1) Power button
Sets the projector to the standby mode when the <MAIN
POWER> switch on the projector is set to <ON>. Starts
projection when the projector power is off and in the
standby mode.
(2) <MENU> button
Displays the main menu.
(3) <INPUT SELECT> button
Switches the input signal to project. (
page 42)
(4)
buttons/<RETURN> button/<ENTER> button
Used to operate the menu screen.
Also used to enter the password for [SECURITY] or to
enter characters.
Connecting terminals
(1) (2) (3) (4) (5) (6) (7) (8) (9)
(1) <LAN> terminal
This is a terminal to connect to the network.
(2) <HDMI IN 1>/<HDMI IN 2> terminals
This is a terminal to input the HDMI signal.
(3) <COMPUTER IN> terminal
This is a terminal to input the RGB signal or the YC
B
C
R
/
YP
B
P
R
signal.
(4) <SERIAL> terminal
This is a RS-232C compatible terminal to externally control
the projector by connecting a computer.
(5) <COMPONENT IN> terminal
This is a terminal to input the YC
B
C
R
signal or the YP
B
P
R
signal.
(6) <VIDEO IN> terminal
This is a terminal to input the video signal.
(7) <S-VIDEO IN> terminal
This is a terminal to input the S-video signal.
This is a terminal to output the audio signal input to the
projector.
This is a terminal to input the audio signal.
Attention
z
When a LAN cable is directly connected to the projector, the network connection must be made indoors.
To Next Page
Loading...
