Chapter 6 Maintenance — FAQ
ENGLISH - 205
g It may improve by ending the mirroring connection once, and then change to a different channel in the
[NETWORK/USB] menu → [MIRRORING] → [CHANNEL]. End the mirroring connection once, and re-
connect.
f Conrm that there is no problem with the used contents.
f It may be caused by the processing performance or the wireless transfer performance of the device in use.
Conrm the specication of the device.
r The connection was disconnected when not doing anything after performing the mirroring
connection.
f Depending on the device in use, it may be set to disconnect the connection after specic time has elapsed.
Conrm the energy saving setting, etc., of the device.
f It may improve by updating the rmware of the device in use or the driver of the wireless LAN. Consult with the
customer support for the device.
r Other
f Depending on the device in use, conrmation screen for reconnection with the connection name of “from
UNKNOWN” may display, but reconnection cannot be performed from that screen.
f Depending on the device in use, it may be requested to “delete the device” at the time of connection. In such
case, delete the device following the instruction of the device.
To Next Page
Loading...
