Panasonic PT-REQ10 - [Remote2 Mode]; [Function Button]; [Status]

Chapter 4 Settings — [PROJECTOR SETUP] menu
182 - ENGLISH
[REMOTE2 MODE]
You can set the <REMOTE 2 IN> terminal.
1) Press as to select [REMOTE2 MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT]
Uses pin assignment of the <REMOTE 2 IN> terminal in standard setting. (x page 289)
[USER]
Changes the setting of the <REMOTE 2 IN> terminal.
f Proceed to Step 3) when [USER] is selected.
3) Press the <ENTER> button.
4) Press as to select one from [PIN2] to [PIN8], and press qw to switch the setting.
[FUNCTION BUTTON]
Set the function of the <FUNCTION> button on the remote control.
1) Press as to select [FUNCTION BUTTON].
2) Press the <ENTER> button.
f The [FUNCTION BUTTON] screen is displayed.
3) Press as to select a function.
[DISABLE]
Disables the <FUNCTION> button.
[SUB MEMORY]
Displays the sub memory list. (x page 198)
[SYSTEM SELECTOR]
Switches the [SYSTEM SELECTOR] setting according to the input signal of the image being
projected.
f When the input is SDI
g The [DISPLAY OPTION] menu → [SLOT IN] → [SYSTEM SELECTOR]
f When the input is SDI OPT1 / SDI OPT2 of Function Board
g The [DISPLAY OPTION] menu → [SLOT IN] → [SDI OPT1] / [SDI OPT2] → [SYSTEM
SELECTOR]
f When the input is anything other than SDI / SDI OPT1 / SDI OPT2
g The [PICTURE] menu → [SYSTEM SELECTOR]
[SYSTEM DAYLIGHT VIEW]
Switches the [SYSTEM DAYLIGHT VIEW] setting. (x page 103)
[FREEZE]
Temporarily pauses the image. (x page 149)
[WAVEFORM MONITOR]
Displays the waveform of the input signal. (x page 149)
[LENS MEMORY LOAD]
Loads the registered lens memory. (x page 154)
[ASPECT]
Switch the aspect ratio of the image. (x page 109)
[PROJECTION METHOD]
Switches the [PROJECTION METHOD] setting. (x page 152)
[GEOMETRY]
Switches the [GEOMETRY] setting. (x page 111)
[ANGLE MONITOR]
Displays the [ANGLE MONITOR] screen. (x page 186)
4) Press the <ENTER> button.
Note
f The [FUNCTION BUTTON] screen can also be displayed by holding down the <FUNCTION> button on the remote control.
[STATUS]
Display the status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.
3) Press qw to switch the pages.
f The page will change each time you press the button.