Panasonic PT-REZ80 - Page 140

Chapter 4 Settings — [DISPLAY OPTION] menu
140 - ENGLISH
When the optional Wireless Presentation System Receiver Board (Model No.: TY-SB01WP) is
installed
Setting [SIGNAL LEVEL] in [SLOT IN] (PressIT input)
1) Press as to select [SLOT IN].
2) Press the <ENTER> button.
f The [SLOT IN] screen is displayed.
3) Press as to select [SIGNAL LEVEL].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO]
Automatically sets the signal level.
[64-940]
Fixes to [64-940].
[0-1023]
Fixes to [0-1023].
When the Function Board by other manufacturers is installed
Setting [SIGNAL LEVEL] in [SLOT IN] (SLOT input)
1) Press as to select [SLOT IN].
2) Press the <ENTER> button.
f The [SLOT IN] screen is displayed.
3) Press as to select [SIGNAL LEVEL].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO]
Automatically sets the signal level.
[64-940]
Fixes to [64-940].
[0-1023]
Fixes to [0-1023].
Note
f The optimal setting varies depending on the installed Function Board and the output setting of the connected external device. Refer to the
Operating Instructions of the Function Board and the external devices.
Setting [EQUALIZER] in [SLOT IN] (SLOT input)
1) Press as to select [SLOT IN].
2) Press the <ENTER> button.
f The [SLOT IN] screen is displayed.
3) Press as to select [EQUALIZER].
4) Press qw to switch the item.
f The items will switch each time you press the button.
f Adjust while viewing the image.
[0] - [7]
Change the setting when the projected image does not stabilize. The higher the value, correction by
the equalizer becomes stronger.
(Factory default setting: [0])
Setting [AUTO GAMMA SELECT] in [SLOT IN] (SLOT input)
1) Press as to select [SLOT IN].