Chapter 2 Getting Started — Setting up
34 - ENGLISH
Setting up
Installation mode
The installation modes of the projector are as follows. Set the [PROJECTOR SETUP] menu → [PROJECTION
METHOD] (x page 125) depending on the installation mode.
Mounting on the ceiling and projecting forward Setting on a desk/oor and projecting from rear
(Using the translucent screen)
Menu item Setting value Menu item Setting value
[PROJECTION METHOD] [FRONT/CEILING] [PROJECTION METHOD] [REAR/FLOOR]
Mounting on the ceiling and projecting from rear
(Using the translucent screen)
Setting on a desk/oor and projecting forward
Menu item Setting value Menu item Setting value
[PROJECTION METHOD] [REAR/CEILING] [PROJECTION METHOD] [FRONT/FLOOR]
Portrait setting and projecting from the rear
(Using the translucent screen)
Portrait setting and projecting forward
Menu item Setting value Menu item Setting value
[PROJECTION METHOD] [REAR/FLOOR] [PROJECTION METHOD] [FRONT/FLOOR]
Note
f In the portrait setting, the on-screen menu is displayed sideways.
To display the on-screen menu in portrait, go to the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] (x page 118) and change the
[OSD ROTATION] setting.
To Next Page
Loading...
