Panasonic PT-RZ11K

Chapter 3 Basic Operations — Switching on/off the projector
62 - ENGLISH
Initial setting (date and time)
Set the local date and time. After completed the initial setting, you can change the setting from the [PROJECTOR
SETUP] menu → [DATE AND TIME].
To set the date and time automatically, refer to “Setting the date and time automatically” (x page 136).
1) Press as to select an item.
20XX
7/7
1
1
12
34
56
MONTH
DAY
HOUR
MINUTE
SECOND
Please set the date and time of the built-in clock of the
projector.
INITIAL SETTING
SET
CHANGEMENU SELECT
YEAR
ENTER
2) Press qw to switch the setting.
3) Press the <ENTER> button.
f Conrm the setting value and complete the initial setting.
Making adjustments and selections
It is recommended that images be projected continuously for at least 30 minutes before the focus is adjusted.
1) 8)
5)
6)
3)
7) 9)
3)
2)
4)
1) 5) 7) 8) 9)2)
6)
1) Press the <FOCUS> button to roughly adjust the focus of the image. (x page 64)
2) Change the setting of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (x page 34)
f Refer to “Navigating through the menu” (x page 76) for the operation of the menu screen.
3) Press the input selection button (<RGB1>, <RGB2>, <DIGITAL LINK>, <DVI-D>, <HDMI>, <SDI 1/2>, or
<SDI>) to select the input signal.
4) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 45)
5) Press the <SHIFT> button to adjust the image position.
6) If the input signal is the analog RGB signal or the DVI-D/HDMI signal, press the <AUTO SETUP>
button.
7) Press the <ZOOM> button to adjust the image size to match the screen.
8) Press the <FOCUS> button again to adjust the focus.
9) Press the <ZOOM> button again to adjust the zoom and the image size to match the screen.