Panasonic PT-RZ120BEJ

Chapter 2 Getting Started — Removing/attaching the projection lens
48 - ENGLISH
Attaching the projection lens
Attach the projection lens using the following procedure.
(ii)
(i)
Guide groove
Guide
Projection lens
Fig. 1
Fig. 2 Fig. 3
Lens Mount Cover
1) Remove the Lens Mount Cover, and align the projection lens guide to the guide groove of the
projector and insert to the end. (Fig. 1)
2) Turn the projection lens clockwise until it clicks. (Fig. 2)
3) Attach the Lens Mount Cover. (Fig. 3)
f Align the Lens Mount Cover and the projector at the dashed line positions in the gure to attach, and turn
the Lens Mount Cover clockwise to x it to the projector.
Attention
f Turn the projection lens counterclockwise to conrm that it does not come out.
f After attaching the projection lens, turn on the projector and conrm the [LENS TYPE] setting. Change the setting if the type does not match
the projection lens attached to the projector. (x page 70)