To Next PageTo Next PageWhy is there no DIGITAL LINK input audio or video on my Panasonic Projector?
If you are experiencing a lack of DIGITAL LINK input audio or video on your Panasonic Projector, verify the following: Ensure the connections between the twisted-pair-cable transmitter and the projector or an external device are correctly established. Check that [DIGITAL LINK MODE] is set to [AUTO] or [DIGITAL LINK] and not to [ETHERNET].
Why don't the buttons on the control panel of my Panasonic PT-RZ470EK operate?
If the buttons on the control panel of your Panasonic Projector are not operating, check if the [CONTROL PANEL] setting in [CONTROL DEVICE SETUP] is set to [DISABLE].
What to do if left and right images are reversed on Panasonic PT-RZ470EK?
If the left and right images are reversed on your Panasonic Projector, ensure that the devices are synchronized and check the 3D eyewear settings. You can also try changing the [LEFT/RIGHT SWAP] setting in [3D SETTINGS].
What to do if 3D eyewear is not functioning with Panasonic PT-RZ470EK Projector?
If your 3D eyewear is not functioning with your Panasonic Projector, consider the following: Check if the batteries in the 3D eyewear are drained; replace them or charge them if they are rechargeable. If using VESA standard 3D eyewear, ensure the IR transmitter is connected properly. Also for VESA standard 3D eyewear, try turning the projector off and on again. Finally, verify that the [3D MODE] setting in [3D SETTINGS] is correct.
Why does the image in the 3D eyewear flicker with my Panasonic PT-RZ470EK Projector?
If the image in your 3D eyewear flickers while using your Panasonic Projector, make sure you are within the reception range. If you are using VESA standard 3D eyewear, check for any obstructions between the 3D eyewear and the IR transmitter.
General| Light Source | Laser |
|---|---|
| Contrast Ratio | 20, 000:1 |
| Display Type | DLP |
| Brightness | 4700 lumens |
| Resolution | 1920 x 1200 |
| Connectivity | HDMI, DVI-D, VGA, LAN |
| Lamp Life | 20, 000 hours |
| Noise Level | 29 dB |
| Input Terminals | DVI-D, VGA, LAN |
Guidelines for safe operation, handling, installation, and use of the projector.
Guidelines for selecting a suitable location and environment for projector installation.
Guidelines for connecting external audio and video sources to the projector.
Procedures for turning the projector on and off, including power indicators.
Steps involved in projecting an image and adjusting its appearance.
Guide to accessing and navigating the projector's on-screen menus.
Settings for adjusting image quality parameters like brightness, contrast, and color.
Adjustments for image positioning, aspect ratio, and keystone correction.
Core settings for projector operation, including ID, projection method, and cooling.
Configuration and management of the projector's network functions.
