Panasonic PT-VMW50 - Page 145

Noise level *
1
37 dB When [LIGHT POWER] in [ECO MANAGEMENT] is set to [NORMAL]
27 dB When [LIGHT POWER] in [ECO MANAGEMENT] is set to [QUIET]
Laser
classication
Laser Class
USA and Canada: Class 3R (IEC 60825-1:2007)
Other countries or regions: Class 1 (IEC/EN 60825-1:2014)
Risk Group
Risk Group 2 (IEC 62471-5:2015)
Operating
environment
Operating
environment
temperature
0 °C (32 °F) to 45 °C (113°F)
*3
Operating
environment
humidity
20 % to 80 % (no condensation)
Remote
control
Power supply DC 3 V (AAA/R03 or AAA/LR03 battery x 2)
Operation range Within approx. 30 m (98'5") (when operated directly in front of signal receiver)
Weight 102 g (3.6 ozs.) (including batteries)
Dimension Width: 48 mm (1-7/8"), Height: 145 mm (5-23/32"), Depth: 27 mm (1-1/16")
*1 Measurement, measuring conditions and method of notation all comply with ISO/IEC 21118:2012 international standards.
*2 This is an average value. It may differ depending on individual product.
*3 The projector cannot be used at an altitude of 2 700 m (8 858') or higher above sea level.
In the following operating environment, the light output may decrease to protect the projector.
f When the projector is operated at an altitude below 700 m (2 297') and the ambient temperature exceeds 36 °C (97 °F)
f When the projector is operated at an altitude between 700 m (2 297') and 1 400 m (4 593') exclusive and the ambient temperature exceeds 34 °C
(93 °F)
f When the projector is operated at an altitude between 1 400 m (4 593') and 2 100 m (6 890') exclusive and the ambient temperature exceeds 32 °C
(90 °F)
f When the projector is operated at an altitude between 2 100 m (6 890') and 2 700 m (8 858') exclusive and the ambient temperature exceeds 30 °C
(86 °F)
Note
f The part numbers of accessories and separately sold components are subject to change without notice.
r Connecting terminals
<COMPUTER 1 IN>
1 set, high-density D-Sub 15 p (female)
RGB signal 0.7 V [p-p] 75 Ω (When G-SYNC: 1.0 V [p-p] 75 Ω)
HD/SYNC TTL high impedance, automatic positive/negative polarity compatible
VD TTL high impedance, automatic positive/negative polarity compatible
YP
B
P
R
signal Y: 1.0 V [p-p] including synchronization signal, P
B
P
R
: 0.7 V [p-p] 75 Ω
<COMPUTER 2 IN/ 1
OUT>
1 set, high-density D-Sub 15 p (female), monitor output compatible
RGB signal 0.7 V [p-p] 75 Ω (When G-SYNC: 1.0 V [p-p] 75 Ω)
HD/SYNC TTL high impedance, automatic positive/negative polarity compatible
VD TTL high impedance, automatic positive/negative polarity compatible
YP
B
P
R
signal Y: 1.0 V [p-p] including synchronization signal, P
B
P
R
: 0.7 V [p-p] 75 Ω
<VIDEO IN>
1 set, pin jack 1.0 V [p-p] 75 Ω
<HDMI 1 IN> /
<HDMI 2 IN>
2 sets, HDMI 19 pin, HDCP and Deep Color compatible
Audio signal Linear PCM (Sampling frequency: 48 kHz/44.1 kHz/32 kHz)
<AUDIO IN 1> /
<AUDIO IN 2>
2 sets, M3 stereo mini jack, 0.5 V [rms], input impedance 22 kΩ and more
<AUDIO IN 3>
1 set, Pin jack x 2 (L-R), 0.5 V [rms], input impedance 22 kΩ and more
<VARIABLE AUDIO
OUT>
1 set, M3 stereo mini jack, monitor output and stereo compatible,
0 V [rms] to 2.0 V [rms] variable, output impedance 2.2 kΩ and less
<USB (VIEWER/
WIRELESS/DC OUT)>
1 set, USB connector (type A), for Memory Viewer function/ Wireless module (Model No.: AJ-WM50) connection/
power supply (DC 5 V, maximum 2 A)
<SERIAL IN>
1 set, D-sub 9 pin (female), RS-232C compliant, for computer control use
<DIGITAL LINK/LAN>
*1
1 set, RJ-45, for network, DIGITAL LINK connection (HDBaseT
TM
compliant), PJLink compatible, 100Base-TX,
HDCP compatible, Deep Color compatible
<LAN> 1 set, RJ-45, for network connection, PJLink compatible, 10Base.T/100Base.TX
*1 Not available for PT-VMZ40.
ENGLISH - 145
Chapter 7 Appendix - Specications